2016 Hyundai Sonata Problems & Defect Complaints

NHTSA received a petition on or about July 18, 2022, requesting that Federal Motor Vehicle Safety Standard (FMVSS) 141 be applied to all electric and hybrid vehicles operating in the United States. The petition can be reviewed at NHTSA.gov under ODI Number 11486072. FMVSS 141 establishes performance requirements for pedestrian alert sounds for motor vehicles. The standard applies to hybrid and electric vehicles that have a gross vehicle weight rating of 4,536 KG or less or are defined as low-speed vehicles. The standard became fully applicable to all such vehicles manufactured on or after March 1, 2021.On January 27, 2023, NHTSA opened Defect Petition (DP) 22-005 to evaluate the subject matter described in the petition. On June 24, 2023 and as supplemented on June 25, 2023, the petitioner notified NHTSA he was withdrawing his petition. The petitioner indicated that, based on his review of data, there is no justification for asserting potential benefits that could be derived from actions sought by my petition. Based on the petitioner's withdrawal, DP22-005 is closed. Closure of this DP does not represent a determination by NHTSA regarding the subject matter of the petition.

The National Highway Traffic Safety Administration (NHTSA) received a letter dated July 13, 2022, petitioning the Agency to initiate a safety defect investigation into loss of motive power allegations attributed to oil drain pan assembly failures on certain Hyundai Motor America, Inc. and Kia America, Inc. vehicles spanning Model Years (MY) 2005-2021. The Petitioners cited examples of complaints indicating that the subject vehicles were experiencing rapid loss of engine oil due to oil drain plug back outs, resulting in loss of motive power and/or catastrophic engine damage. Additional complaints were provided which alleged that the oil drain pans lack sufficient structural integrity and are susceptible to cracking. The petition itself can be reviewed at NHTSA.gov under ODI number 11481745. On September 12, 2022, the Office of Defects Investigation (ODI) opened Defect Petition (DP22-003) to evaluate the Petitioners’ request. The Petitioners have provided additional complaints within four supplemental letters dated January 31, 2023, March 21, 2023, May 23, 2023, and August 4, 2023. ODI’s evaluation included the review and analysis of the complaints and supporting information submitted by the Petitioners, as well as additional complaints submitted directly to NHTSA which referenced either the oil drain plug or a crack in the oil pan. After reviewing the available data, ODI has not identified evidence that would support opening a defect investigation into the oil drain pan assemblies of the subject vehicles. Based on a review of the available information, a loss of motive power resulting from an oil drain plug back out has not occurred between the initial sale of a vehicle and the completion of its first oil change. If during an oil change service, a technician fails to remove the existing drain plug gasket before installing a new gasket, it is likely that a proper seal between the drain plug and the oil pan will not be made. An improper seal between the drain plug and oil pan could lead to the backing out on the drain plug, resulting in the sudden loss of oil while driving. Additionally, the provided examples of oil pan cracks were localized to the immediate vicinity of the oil drain plug and/or appeared to be the result of direct-contact with a tool during servicing.  There is no information to support that a vehicle-based defect exists relating to the oil pan assembly, and instead the documented incidents are related to the failure to follow the proper maintenance procedures during oil change service. In October 2023, Hyundai published a Technical Service Bulletin (TSB) that provided detailed instructions for oil change service on its gasoline powered vehicles, specifically highlighting the need to remove and replace the existing drain plug gasket prior to reinstalling the drain plug. After a thorough review of the material submitted by the petitioner, the information already in NHTSA's possession, and the potential risks to motor vehicle safety implicated by the petitioners' allegations, NHTSA does not believe that a formal investigation is warranted. Therefore, the petition is denied. A Federal Register Notice (FRN) further detailing NHTSA’s reasons for denial of the petition will be published. The reference numbers for the complaints to NHTSA cited by the petitioner can be found in the petition submission documents in the public file for DP22-003. To review those complaints and the additional complaints ODI added to its evaluation which are cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.

On March 29, 2019, the Office of Defects Investigation (ODI) opened two Preliminary Evaluations (PE19-003 on Hyundai and PE19-004 on Kia) to broadly investigate incidents of non-crash fires (regardless of origin or operational status of the vehicle) on various model year Hyundai and Kia vehicles.  During the PE investigations, Hyundai and Kia issued several recalls to address vehicle fires, including those due to engine failures involving various engine types.  The remedies for the engine failure recalls typically involve engine inspection (to detect existing damage), and if necessary, engine replacement.  Additionally, both manufacturers have been installing an engine control software modification known as Knock Sensor Detection Software (KSDS) which is intended to detect impending engine failure, alert the driver, and limit engine power (to lessen likelihood of engine failure).KSDS is being installed under recalls and non-safety field actions, and both companies have extended limited engine warranties (see recall files). On December 22, 2021, ODI upgraded PE19-003 and PE19-004 to this Engineering Analysis (EA21-003, covering both Hyundai and Kia) to evaluate the scope of the prior recalls related to engine failures/fires and the efficacy of the recall remedies for the recalls, as well as the long-term viability of related programs and non-safety field actions being conducted by Hyundai and Kia.  The former issue involved approximately 550,000 MY 2013 Hyundai Elantra, MY 2011 Kia Sorento, and MY 2012-2015 Kia Rio.  The latter issue involved approximately 2.5 million recalled vehicles, which have been identified as displaying potential remedy concerns: Hyundai recalls 15V-568, 17V-226, 20V-746, and 21V-727; and Kia recalls 17V-224, 19V-120, 20V-750, and 21V-844. Regarding the recall scope issue, among all of the scope vehicles identified at EA opening, ODI found only the MY 2011 Kia Sorento vehicles equipped with both the Theta II 2.4L 4-cylinder Multi-Point Injection (MPI) and the Lambda II 3.5L 6-cylinder MPI engines experienced relatively high rates of reported fires.  In December 2023, Kia issued recall 23V-877 that will cover about 80,000 MY 2011 Kia Sorento vehicles equipped with the Theta II 2.4L MPI engines.  The remedy will involve an inspection, and if necessary, a replacement of the engine, as well as the installation of KSDS.  It should be noted that in 2021 these vehicles were included in a KSDS product improvement campaign with warranty extension.  For the MY 2011 Sorento vehicles equipped with the Lambda II 3.5L engines, ODI believes that future engine failures/fires involving these vehicles will likely be due to a lax in adhering to the proper or scheduled engine maintenance (regular engine oil changes), rather than a design or manufacturing engine issue. Regarding the issue of the efficacy of the recall remedies, ODI found the majority of the recalled Hyundai and Kia vehicles, by model, experienced lower reported fire rates after the remedies were applied.  Furthermore, ODI found that for most vehicles that did not receive the recall remedies, by model, experienced relatively high fire rates.  To address this problem, Hyundai informed ODI in December 2023, that it will renotify all of its owners covered by the Hyundai recalls of engine failures/fires every 8 months for the next 3 years.  In December 2023, Kia stated that it will renotify the majority of its owners every 8 months for the next 3 years.Several previously recalled Kia models are excluded from the renotification due to their lower reported rates of engine fires.  Overall, the renotification actions will help to increase the recall completion rates, thus reduce the frequency of engine fires in the future. In view of the recall action being taken by Kia and renotification actions being taken by both Kia and Hyundai, ODI is closing this Engineering Analysis.  Also, both companies have been released from the 2020-iniated Consent Orders (Kia since November 2022 and Hyundai since November 2023).  The agency reserves the right to take additional action if warranted by future circumstances.  To review the reports cited in the Closing Resume ODI Report Identification Number document, go to NHTSA.gov.

The Office of Defects Investigation (ODI) opened this investigation to determine if the failure of airbags to deploy during severe crashes, in certain vehicles, was the result of a safety related defect.  During the investigation a complex failure was studied that can result in non-deployment of subject vehicle air bags and other restraint system devices in severe crash events. The subject vehicles may be equipped with an airbag control unit (ACU) for the supplemental restraint system (SRS) Electronic Control Unit (ECU) manufactured by ZF-TRW.  The ECU receives signals from crash sensors mounted in the vehicle and deploys the vehicle air bags and seat belt pretensioners in accordance with manufacturer design specifications.  The ECU in the subject vehicles contains a model DS84 application-specific integrated circuit (ASIC) which controls the communication of the crash sensor signal, firing commands (i.e., when to deploy the airbag(s) and/or pretensioners), and fault information (e.g., diagnostic trouble codes). In September 2016, FCA announced recall 16V-668 for certain model year (MY) 2010 to 2014 Chrysler, Dodge and Jeep products manufactured with the subject ZF-TRW ACU.  In this recall, FCA discussed an EOS condition that resulted in a failure of the subject DS84 ASIC, which caused air bag non-deployment.  FCA noted that the defect condition had only been observed in vehicles equipped with sensor harnessing routed across the front of the vehicle.  Other FCA vehicles that also used the subject ACU, but were not equipped with cross-car harnessing, had not experienced EOS failures, despite similar time in service. During the course of this investigation, ODI sent two separate Information Request (IR) letters to six vehicle manufactures (including FCA, Hyundai, Honda, Kia, Mitsubishi, and Toyota) and one IR letter to ZF-TRW.  These IR letters resulted in ODI receiving comprehensive data from these manufacturers and suppliers. Studies of this data found that the DS84 ASIC does not have sufficient protection against negative electrical transients or electrical overstress (“EOS”) that can be generated in certain severe crashes.  An electrical transient occurs when the electrical power supplied to a circuit changes momentarily over a short duration of time.   In these severe crash cases, the crash sensors and other powered wiring can be damaged and short circuited so as to create a negative electrical transient of sufficient intensity and duration (that are outside the vehicle manufacturer's specification) to damage the ASIC before the restraint device deployment signal is received by the SRS ECU.  This damaged signal can lead to incomplete or nondeployment of the air bags and/or pretensioners.  Airbag non-deployment and/or lack of pretensioner operation can increase the risk or severity of injury in a crash.A total of 8 fatalities and 14 injuries were associated with known EOS events. The common element in all investigated manufacturers vehicles is the SRS ECU containing a DS84 ASIC manufactured by ZF-TRW.  The risk associated with the ASIC is equally shared among all OEMS involved in the investigation.  The actual real-world risk can be mitigated by other factors which were assessed by ODI during this investigation. The first mitigating factor involves protections built into the ACU design which protect the DS84 ASIC from damage.  There are multiple strategies and levels of protection employed by different OEMs that provide effective EOS mitigation.  The two most common strategies at the ACU level are circuit protection diodes on the remote senor signal lines, and current limiting resistors that protect critical components. The second mitigating factor is found at the vehicle level and involves the location and routing of the wires leading from the crash sensors to the SRS ECU.  If the wires are well protected in a crash and are not routed with other power wires carrying large currents, the risk for an EOS event is significantly reduced or eliminated. These design specific factors combine to produce a spectrum of risk for the vehicles equipped with ACUs using the DS84 ASIC.  Given the many of years of field exposure, it is possible to divide the subject population into two groups; vehicles which have experienced EOS events, and vehicles which have not experienced EOS field events. Four of the six OEMs involved in this investigation have experienced EOS field events on at least one of their models equipped with a DS84 ASIC.  All vehicle models (including the Toyota models identified in the Failure Report Summary of the opening resume for this investigation) with field events have been recalled.  In an abundance of caution, ODI kept this investigation open five years to monitor field performance and did not identify any field events on vehicles not included in existing safety recalls. Given the spectrum of risk identified in this investigation and that all vehicles with a demonstrated unreasonable risk have been recalled, ODI is closing this investigation. ODI is closing this investigation with the following manufacturer safety recalls: 16V-668, 18E-043, 18V-137, 18V-363, and 20V-024.  With the recall actions taken by the subject vehicle and equipment manufacturers, this investigation is closed. The closing of this investigation does not constitute a finding by NHTSA that a safety-related defect does not exists on other model or model year vehicles outside of the recall scopes. The agency reserves the right to take further action if warranted by the circumstances.

The Office of Defects Investigation opened this investigation on September 3, 2016 based on four reports alleging the rear brakes locked or applied while driving without brake pedal application. One of the reports alleged a fire in the right rear wheel area.The vehicles subject to the investigation are equipped with an optional Electronic Parking Brake (EPB). In this system, an electric motor applies the parking brake by moving the rear brake pads (pads) against the brake rotors (rotors) when activated by the EPB control switch. The EPB is released by the control switch or by selecting a drive gear with the transmission shifter when the ignition is on.If the EPB has not been used within 1000 kilometers (621 miles) the system is designed to perform an Automatic Adjustment Function (AAF) of the pads to check for proper clearance. This function is a pad adjustment only and is preformed with the vehicle in park with the ignition off. It does not set the parking brake or turn the brake indicator light on. Hyundai has identified an error within the EPB control logic that can cause the pads to remain in contact with the rotors at various levels of force after the AAF is completed. This condition could cause the rear brakes to drag at the next drive cycle and may generate some levels of heat and smoke. The EPB control logic error affects model year 2016 vehicles produced from the start of production through March 16, 2016.Vehicles produced from March 17, 2016 incorporate an updated EPB control logic to prevent brake pad drag. On May 11, 2016 Hyundai notified its dealer network of Service Campaign TFF to update the EPB control logic in the affected vehicle population. Dealers will reflash the EPB software to prevent brake pad drag.There are no reports of accidents or injuries as a result of this issue. The incident that alleged fire could not be confirmed as there were no repairs to the vehicle other than replacement of the rear brake rotors and pads.ODI is closing this investigation based on the manufacturer's Service Campaign of the affected vehicles and in consideration that the the effect of brake drag in this instance does not appear to present an unreasonable risk to motor vehicle safety. The ODI reports cited above can be viewed at www-odi.nhtsa/complaints under the following identification (ODI)numbers: 10820359, 10854476, 10875764, 10892736, and 10928478